Product Description
This fitting joins two tubes into a tee joint. It is mainly used in handrails where the top rail is required to meet Australian Disability Standard: AS1428. It is only available in size C and D.
This fitting requires the handrail tube to be drilled and fastened with appropriate screws or rivets (not supplied).
The fitting can then be attached to stanchion post in C42 (TC755C) or D48 (TC755D). The assembly comes from TC555, TC173F, bolt and nut
Often used with TC754 for change direction, BAR 723 for J Bend Handrail Termination or TC765 for Wall End Railing Termination or TC767 for End Post Termination
Common Usage
We use 755 swivel tee to make DDA railing without the use of sleeve-on (standard) fittings.
Similar products
|
TC751 |
751 - DDA Assist Swivel Inline Half Tee |
Half Saddle Bracket |
*Figures given as guidance only, dimensions and weights are subject to manfacturing tolerances and may be altered without prior notice.
| Product: | TubeClamp® fittings |
| Material: | Fittings cast of malleable cast iron - galvanized finish |
| Set Screw: | Cup Point Case hardened setscrew in 45CR Alloy Steel (alternative* Stainless Steel 308) |
| Feature: | No Welding Slip on Structural Fittings |
| Tensile Load: | min 5,650 N axial load subjected to 40Nm tightened torque (FOS 2.0 min) |
| Testing: | Internally by Solid Dynamics Engineering Pty Ltd. Testing videos are available upon request |
| Design: | Tubeclamp Structural Fittings, when properly installed per manufacturing recommendations, meet or exceed all applicable requirements as specified by Australian Standard |
| Applications: | Handrails, Trolley Bays, Temporary Structure, Shop Fittings, Furnitures and many more. |